How To Attach Kitchen Cabinets Brick Wall

August 31, 2019
By admin
Filed Under Kitchen Cabinets
No Comments

How To Attach Kitchen Cabinets Brick Wall

Attaching kitchen cabinets to a brick wall is a necessary step when remodeling or installing a new kitchen. It requires careful planning, preparation, and execution to ensure the cabinets are securely and evenly attached. This article will delve into the essential aspects of attaching kitchen cabinets to a brick wall, providing a comprehensive guide for DIY enthusiasts and professional contractors alike. ### 1. Preparing the Wall The first step involves preparing the brick wall for cabinet installation. This includes cleaning the surface, removing any debris or loose mortar, and leveling any uneven areas. Use a wire brush or power washer to remove dirt and grime. Fill any holes or cracks with a mortar mixture and allow it to set completely. Ensure the wall is dry and free of moisture before proceeding. ### 2. Marking the Cabinet Locations Once the wall is prepared, mark the locations where the cabinets will be attached. Use a level to ensure the cabinets are aligned horizontally and vertically. Draw a plumb line to mark the vertical center of each cabinet and transfer these measurements to the wall. Use a chalk line to snap guidelines for the top and bottom of the cabinets. ### 3. Installing Wall Cleats Wall cleats are essential for attaching cabinets securely to a brick wall. Cut cleats from 1x4 lumber and space them evenly along the guidelines marked on the wall. Use long, galvanized screws or masonry bolts to attach the cleats to the brick. Ensure the cleats are level and securely fastened. ### 4. Pre-Drilling Holes Before mounting the cabinets, pre-drill holes into the brick wall through the wall cleats. Use a masonry drill bit and a hammer drill to create holes slightly smaller than the screw diameter. This will prevent the brick from cracking when the screws are driven in. Vacuum any dust or debris created during drilling. ### 5. Mounting the Cabinets Lift each cabinet into place and align it with the corresponding wall cleats. Use galvanized screws or masonry bolts to drive through the pre-drilled holes into the wall cleats. Start by hand-tightening the screws and then use a screwdriver or impact driver to fully secure them. Ensure the cabinets are level and plumb before tightening all screws. ### 6. Leveling and Adjusting Once the cabinets are mounted, use a level to check for any unevenness. Adjust the height of the cabinets by adding shims or spacers between the wall cleats and the cabinet base. Use a pry bar or a mallet to gently tap the cabinets into the correct position. ### 7. Securing the Cabinets Finally, ensure the cabinets are securely attached to the brick wall. Use mending plates or L-brackets to reinforce any areas that may need additional support, such as under sinks or corner cabinets. Tighten all screws and bolts regularly to maintain the integrity of the installation.