Diy Staining Old Kitchen Cabinets

May 17, 2019
By admin
Filed Under Kitchen Cabinets
No Comments

DIY Staining Old Kitchen Cabinets: Step-by-Step Guide

Refinishing old kitchen cabinets with stain is a cost-effective way to update the look of your kitchen without replacing them. While it may seem like a daunting task, it's surprisingly straightforward with the right tools and materials.

Before you begin, it's important to choose the right stain for your cabinets. Oil-based stains are more durable and water-resistant, while water-based stains are easier to apply. Once you've chosen your stain, gather the following tools and materials:

Sandpaper (120-grit, 220-grit)
Tack cloth
Degreaser
Wood filler
Putty knife
Stain
Foam brush or sponge
Clean rags
Polyurethane

Now that you have everything you need, let's get started!

Step 1: Remove Doors and Hardware

Begin by removing all of the cabinet doors and hardware. This will make it easier to sand and stain the cabinets.

Step 2: Clean and Degrease

Next, clean the cabinets thoroughly with a degreaser. This will remove any dirt, grease, or debris that could prevent the stain from adhering properly.

Step 3: Sand

Sand the cabinets lightly with 120-grit sandpaper. This will create a smooth surface for the stain to adhere to. Once you're finished sanding, vacuum up the dust and wipe down the cabinets with a tack cloth.

Step 4: Repair Imperfections

If there are any imperfections in the cabinets, such as dents or scratches, fill them in with wood filler. Let the wood filler dry completely, then sand it smooth.

Step 5: Apply Stain

Now it's time to apply the stain. Use a foam brush or sponge to apply an even coat of stain to the cabinets. Follow the grain of the wood and work in small sections.

Step 6: Allow to Dry

Allow the stain to dry completely according to the manufacturer's instructions. This may take several hours or overnight.

Step 7: Apply Polyurethane

Once the stain is dry, apply a coat of polyurethane to protect the finish. You can apply polyurethane with a brush or spray gun. Allow the polyurethane to dry completely and apply additional coats as needed.